Ford Ranger DPF regeneration in Stoke‑on‑Trent

A diesel particulate filter that never gets a long enough run fills with soot, and the Ford Ranger lights up its DPF warning or drops into limp mode. We hold 15 diesel Ranger engines: pick yours below and we will clear the filter and fix what blocked it.

A DPF regeneration on a diesel Ford Ranger burns the soot out of the filter, and we fix what stopped it clearing itself, at our unit in Fenton, Stoke-on-Trent. It is priced on request. We hold 15 diesel Ranger engines: pick yours below, then message us with your reg.

Ford Ranger Ranger IV

Find your engine

Generation

The 2.0 EcoBlue 170hp has a diesel particulate filter, so a forced DPF regeneration applies to it.

Price on request: message us with your reg

Stage 1 on this engine: typically 200 to 210bhp from 168bhp stock

Message us about this engine

What a DPF regeneration is

Every diesel Ranger has a diesel particulate filter that traps soot and burns it off on longer runs. Short journeys stop that happening, the filter fills, and the car shows a DPF light or drops into limp mode. A forced regeneration burns the soot out in the workshop and the filter stays on the car.

Why Ranger owners ask for it

  • Clears a blocked filter without the cost of a new one
  • Gets the car out of limp mode and back to full power
  • The filter stays in place, so nothing changes for the MOT

How it works

  1. Diagnose

    We read the fault codes, the soot load and the differential pressure, and look for the cause: a faulty sensor, an EGR fault or a run of short journeys.

  2. Fix the cause

    Anything that stopped the filter regenerating on its own is dealt with first, or it will block again.

  3. Forced regeneration

    We run a forced regeneration with dealer-level diagnostics, burning the soot out of the filter under control.

  4. Check and hand back

    We check the soot load and pressure readings again and clear the codes before the car goes back to you.

Pair it with a remap

A clear filter is the right time for a Stage 1 remap too. The 3.0 EcoBlue 240hp typically goes from 237bhp to around 270 to 290bhp at Stage 1, from £249.

Typical gains for every Ranger engine

Other emissions services for the Ranger

Ford Ranger DPF regeneration FAQ

Ranger DPF regeneration questions

It is priced on request. Message us with your reg and the warning you see.

It burns the soot out of the diesel particulate filter, and we fix what stopped the Ranger clearing it itself.

A DPF warning light, or the car dropping into limp mode, typically on a car that never gets a long enough run.

Still have a question? Message us with your reg and what you would like done.

07927 860502